0.项目概述：Project Overview

　　马来西亚IED公司位于雪兰莪州，本次项目主要用于马来西亚槟榔医院的3套12路绝缘故障定位，主要用的产品有绝缘监测仪AIM-M200,测试信号发生器ASG150,集中报警与显示仪AID150,绝缘故障定位仪AIL150-8,AIL150-4以及漏电流互感器AKH-0.66P26.

　　Malaysia I.E.D is located in SELANGOR DARUL EHSAN，the project is mainly used in island hospital in Malaysia,the products are used for 12 circuit insulation fault location for 3 sets hospital isolated power system,the related products are insulation monitor device AIM-M200,signal test generator ASG150,centralized alarm indicator AID150,insulation fault locator AIL150-8,AIL150-4 and leakage current transformer AKH-0.66P26.

　　1.医疗IT系统介绍Medical IT system Introduction

　　医用IT系统绝缘监测故障定位装置及系统适用于医院的手术室、ICU(CCU)监护病房等重要场所，能为这类场所提供安全、连续、可靠的供电解决方案。

　　ACREL medical IT system insulation monitoring device and fault location system is suitable for hospital operating room, ICU (CCU) and other important places, and can provide a safe place for such continuous, reliable power solutions.

　　2.医疗场所供电解决方案Power Supply Solution for Medical Locations

　　2.1 ICU、CCU病房配电解决方案（以GGF-I8G隔离配电柜系统图为例）

　　2.1ICU, CCU ward Distribution Solutions (GGF-I8G isolate electrical cabinet system diagram, for example)

　　方案一  不带故障定位功能

　　Option I  without fault location function

　　方案二 带故障定位功能

　　Option II  with fault location function

　　注：在重症监护室的配电解决方案中，AID系列集中报警与显示仪应该安装在护士站内，由护士站的医务人员来监视各隔离电源系统的运行状况。

　　NOTE: In the power distribution solutions of intensive care unit , AID series centralized alarm and display device should be installed in the nurses 'station, the hospital staff of nurses' station monitor the Operating status of each isolated power system

　　2.2手术室配电解决方案（以GGF-O8G隔离配电柜系统图为例）

　　Operating Room Distribution Solutions (GGF-O8G isolate electrical cabinet system diagram, for example)

　　方案一 不带绝缘故障定位功能

　　Option I  without insulation fault location function

　　方案二 带绝缘故障定位功能

　　Option II  with insulation fault location function

　　注：1.在手术室的配电解决方案中，AID系列外接报警与显示仪应安装于手术室内部情报面板上，或情报面板的旁边（嵌墙安装）。在手术过程中，由医务人员来监视隔离电源系统的运行状况。

　　2.带绝缘故障定位功能的方案中，如果需定位回路超过8路，可采用两套AIL150定位仪来实现，其组合可以是AIL150-8型+AIL150-4型(可多定位12路)，或AIL150-8型+AIL150-8型（可多定位16路）。

　　Note: 1. In the operating room power distribution solutions, AID series of external alarm and display device should be installed on the intelligence panel inside the operating room, or next to the intelligence panel (wall mounted installation). During surgery, the medical staff monitor the health of isolated power system.

　　2. In the scheme with insulation fault location function，if the number of located channels  is more than eight，two sets of AIL150 locator can be used. The combination can be AIL150-8  and AIL150-4 (up to 12 channels), or AIL150 -8 and AIL150-8 (up to 16 channels).

　　3.接线图Typical wiring diagram

　　4.医疗IT七件套产品介绍 Introduction of 7-Piece Medical IT